Manual white board of 50 (box 1.5 m2)

It is an imperfect platelet, whose measurements are not exact, manufactured with the intention of being all different, with random edges. The measurements of each platelet are:

• Width: 23 cm
• Height: 5 cm
• Thickness: 1.5 cm

The measurements of the complete mesh:

• Width: 60 cm
• Height: 25 cm
• Thickness: 1.5 cm

Each mesh has 10 platelets. Each box has 10 meshes, which are 1.50 m2

Where can it be placed?

The bricks can be laid both indoors and outdoors. It is a highly used product and adapts perfectly to any environment.

To indicate some rooms where it is most commonly used, we can indicate these:

• Rustic dining rooms
• Chimneys and surroundings to it.
• Hallways
• Small wineries
• Interior living room wall, to mix with other totally smooth ones (industrial interior design)
• Garden areas and fountains.

How are imitation brick tiles placed?

• Step 1: Prepare the wall for the correct placement of the platelets. The surface where the platelets are to be placed must be maestered and clean, so as not to have problems with adhesion with the mortar.
• Step 2: It is recommended that the placement of the imitation brick tiles be placed on small cloths of no more than 2 m2. Therefore, first spread the mortar on the substrate, respecting this methodology for its placement.
• Step 3: Once the mortar has been spread, place the imitation brick tiles and press them to ensure their placement, respecting the spaces in the joints that the tiles already have fixed in the fiberglass mesh.
• Step 4: For grouting it is recommended that it is not done until the platelets are fully fixed and the mortar is dry. It is recommended to use a glue gun to grout the spaces between the bricks.
• Step 5: Depending on the material used for grouting will require a reasonable amount of time to remove the rest of the grouting with scrapers and spans. Normally, about 30 minutes will be enough.
• Step 6: Once the whole set is dry, clean it definitively and it will be completely finished.