Impermor 5 Liters Water-repellent

Water-repellent primer colorless by impregnation and waterproofing of water that can be used for the treatment of mineral supports, especially for the completion of exposed works of mortars, natural stone. It has excellent properties as a water-repellent. This primer acts as an excellent barrier to capillary water absorption without forming a film on the substrate. Does not clog pores. Maintains high permeability to water vapor. It prevents against the harmful effects caused by humidity by avoiding them or at least reducing and delaying the appearance of damage.

Features & Applications

• Excellent properties as a water-repellent.
• Excellent barrier to capillary water absorption without forming film on the support.
• Does not clog pores. Maintains high permeability to water vapor.
• It prevents against the harmful effects caused by humidity by avoiding them or at least reducing and delaying the appearance of damage.
• Effective resistance to alcasis attack.
• Good penetration power.
• With condensation catalyst to achieve maximum efficiency faster.
• Adequate resistance to ultraviolet rays.
• It does not produce shine, stickiness or yellowing on surfaces.
• Reduces the fouling of the wall and the proliferation of algae.
• Ideal for restoration works of natural stone walls.

Stands

It must be applied to construction supports of mineral origin such as:

• Masonry of bricks and lime and sand blocks.
• Porous limestone.
• Concrete, especially porous concrete, and mineral plasters.
• Fibre cement boards.
• Natural and artificial stones with a mineral base.
• Granite, mineral plasters, etc.
• Not suitable for waterproofing plaster

How to use

• It should be applied by sprinkler or irrigation, saturating the surface to be treated.
• The face must be plastered two or tres times continuously without the need for total drying between one application and the next.
• A slight humidity of the substrate is recommended, although it cannot be applied in cases where surface moisture stains are observed and in general when it is expected that the substrate may be openworked.
• Application in conditions of high temperatures, or dry and windy weather should be avoided as the effectiveness of product penetration is reduced.
• Its application on dry or hot substrates should be avoided, as the penetration of the product and its subsequent reaction is reduced, reducing its effectiveness