Pumaflex 4 Liters White Acrylic Rubber Bottle

Waterproofing coating. It provides continuous coverage capable of preventing water leaks and the consequent problems derived from humidity. Coating perfectly adhered to the surface, with high flexibility, elasticity and mechanical resistance, which excellently withstands the conditions of its application outdoors and maintains its properties for a very long time due to its excellent durability.

Features & Applications

• Excellent water and liquid tightness in general.
• Strong tensile strength and elongation to break
• Outstanding resistance to aging, abrasion and perforation
• Good product homogenization and easy application
• Film resistant to weather and ultraviolet rays.
• Excellent abrasion resistance.
• Good crack filling and resistant to microcracking.
• Increased mechanical strength with the use of fiberglass mesh.

Stands

NEW SURFACES

• Concrete, cement, plaster, brick, stone, fibre cement, etc., must be set, dry, firm and free of dirt or grease.
• Treat efflorescences or saltpeter with diluted acid solution, rinse and allow to dry.
• Surfaces should be free of moss and microorganisms, dry or very slightly damp.
• In case of cracks, holes or chips, repair prior to application of the product.
• Remove dust, grease and other contaminants.
• Apply the paint according to how it is used.

OLD SURFACES

• Concrete, cement, plaster, brick, stone, fibre cement, etc., must be set, dry, firm and free of dirt or grease.
• Treat efflorescences or saltpeter with diluted acid solution, rinse and allow to dry.
• Remove mold contamination with bleach or other suitable decontaminant, as well as loose parts of paint or other building materials.
• On substrates in poor condition, with lack of cohesion or with moisture problems, apply water-repellent sealant beforehand.
• In cases of cracks, holes or chipping, repair prior to applying the product.
• Old paint should be brushed to remove loose particles, clean and degrease.
• Apply the paint according to how it is used.

How to use

• Shake until perfectly homogenized.
• Dilute the first layer by 5% with water.
• Apply the second and subsequent coats undiluted, in the opposite direction to how the last coat was applied.
• To obtain the optimal performance and durability of the waterproofing, at least 1.5 l/m² of surface area must be used.
• On frequently used walls, a fiberglass or polyester weave must be placed on the first hand without diluting. – The successive cuts of this must be superimposed by about 10 cm, leaving on top the part that coincides with the slope of the ground. The frame must be stretched, without folds and then covered with successive coats of waterproofing.
• The application can be done with a brush, roller or spray gun, after agitating the product and diluting the respective product.
• The utensils should be cleaned with water before the paint dries.