Geotextile Rooftex V 120 2.20x150 m

Non-woven geotextile, made from short polyester fiber of 120 (+10%;-20%) g/m², mechanically bound by piercing without application of chemical binders, pressures or heat. Density: 120gr/m²Uses

• As a separating layer to avoid direct contact with incompatible materials. Uses: walkable and non-passable roofs.
• Rehabilitation of deteriorated waterproofing, acting as a separating layer between the old waterproofing material and the new sheet.
• It can be used for DIY and gardening work in villas, single-family residences, etc., such as:
• Reinforcement of the structure of terraces, tennis courts, avoiding the appearance of potholes and fissures
• Waterproofing protector in swimming pools, small ponds, etc
• To increasethe durability of buried works, such as drainage pipes in gardens, septic tanks, etc
• To avoid mixing materials in planting work, storage of materials, firewood, etc
• To facilitate the settlement of land in gardens.

Advantages

• Prevents aggression or adhesion between two different materials.
• Resistant to active substances in the soil and to inclement weather
• Easy installation, allowing it to be adapted to all types of supports, without the need for overly complex equipment or specially qualified personnel.

Proceeds

• It keeps the mechanical and hydraulic properties of the materials it separates intact.
• High durability
• It shortens the duration of the work and its cost.

Price per roll of 330^m2

How to use

Preparation of the support:

• The surface of the base support must be resistant, uniform, compact and dry.
• The singular points must also be prepared before starting the installation of the geotextile: chamfers or straps in meetings with vertical walls, reinforcements, joints and other singular points.

Geotextile Placement:

• Once the ground or support is leveled, the roll of DANOFELT PY 120 is extended. The second roll is then assembled, leaving a minimum overlap of 20cm. Depending on its final application, it is recommended to fix the joint by sewing or stapling.
• The pouring of the materials must be done without damaging the geotextile. In the same way, the spreading of the different layers will be carried out in such a way that the extension and compaction equipment does not circulate at any time on the surface of the geotextile, and always in such a way that the direction of advance of the extension machinery of the upper layer is carried out in such a way that it does not affect the overlap of the geotextile layers.