Height supplement for the Peygransystem

This supplement has been manufactured to expand the functionalities of the Peygran system, allowing to work in thicknesses of 3 to 5 mm. The height of the supplement is 4 mm. It can be used both in thicknesses below 5 mm and in thicknesses from 17 to 20 mm (together with the bases or chocks for stone). It is placed on the base or chock, under the wedge, allowing the wedge to be centered and offering a greater support surface. This is very important, especially in coatings, as they are such delicate formats. When using it with the pliers, the scale of the same must increase 3mm over the thickness of the piece. These pieces are reusable.

How many pieces would you need per m2?

Very easy, just look at the table and you will know how many you need. It depends on the dimensions A and B of the ceramic tile you are going to install. For example, if the tile measures 45 x 30 cm on each side, you will need 30 pcs per square meter. You should keep in mind that foundations are not reusable and wedges are.

HOW TO USE

Bracket placement:

After spreading the cement glue, place the supports under the pieces on all 4 sides.
For large parts use one or more supports per side.
Place the tile and hit with the rubber mallet.

Insertion of the wedges:

Insert the wedges into the housing by squeezing without exceeding the breaking point.
To facilitate this task, the use of the adjustable traction clamp is recommended.

Removal of the support:

Once the glue cement has set, to tear off the support simply tap with the rubber mallet or with the tip of your foot in the direction of the joint.