High-performance cementitious adhesive with reduced slip and extended open time, for the installation of interior and exterior floors, interior cladding and skirting boards. Especially recommended for tiling swimming pools with vitreous or gressite mosaic and tiling on plasterboard (KNAUF or PLARDUR type). For gluing ceramic pieces with medium-high absorption degrees, marble, mosaic and glass paste
Composition
Product based on high-strength cement, selected aggregates, additives and synthetic resins that guarantee high grip strength, good workability and resistance to aging.
Features & Applications
- Application indoors, outdoor pavements and skirting boards. Adhesion of ceramic pieces with medium-high degree of absorption. It avoids having to moisten parts or supports thanks to its water retention power.
- Reduced slippage.
- Excellent initial adhesion.
- High open time, allows the rectification of parts.
- Moisture resistant.
- Pool tiling.
Stands
- Conventional cement-based supports.
- Plasterboard-interiors (PLADUR type).
- The supports must be resistant, stable, healthy and clean, free of dust, remains of release agents, organic products, etc.
- All supports must be of the appropriate flatness. If not, make screeds of up to 5 mm with the same product 48 hours before gluing. For greater thicknesses, use traditional dry mortars or leveling paste.
- In case of heat, wind or on highly absorbent supports, it is advisable to moisten the support and wait for the water film to disappear.
- Do not apply to plasters or paints.
How to use
- Add water and mix manually or mechanically to a homogeneous and workable consistency.
- Let the dough rest for about 5 minutes and knead.
- Spread the kneaded product on the support with a trowel in a maximum extension of 2m2.
- Comb with a notched trowel to adjust the thickness (see box).
- Place the pieces by pressing and moving until the grooves are completely flattened and their entire surface adheres correctly.
- Respect the construction joints (expansion, contraction, fractionation, perimeter corner joints) and the joints between plates (minimum 2 mm).
- The joints will be filled after 24 hours on vertical walls and 48 hours on pavements. Use the appropriate mortar from the MORCEMCOLOR range, depending on the type of joint.
NOTE: The shorter the time between combing and tile placement, the better results will be obtained.
