Morcem Ready-to-use gasket pasta 5kg

Prepared for the treatment of joints in laminated plasterboard systems.

Features & Applications

• Application with joint tape for the filling and termination of joints between laminated plasterboards.
• Plaster of screw heads.
• Smooth and flat surface.
• Ready to receive the decoration work.
• Minor repairs of assembly defects or slight irregularities.
• Manual or mechanical use.
• Not suitable for the treatment of joints without tape.
• Finishing Nivel: Q4.

Stands

• Laminated plasterboard.
• The supports must be resistant, stable, healthy and clean, free of dust, other release agents, organic products, etc.

How to use

• Knead with clean water (9 liters per 20 kg bag) and mix with a mechanical whisk until you get a homogeneous, workable consistency without lumps.
• Let stand for 10 minutes.
• Fill the joints with paste and glue the tape.
• Flatten with the help of a spatula, removing the excess and avoiding leaving lumps and air bubbles under the joint.
• Allow to dry completely and apply successive layers of paste according to the required finishing nivel , respecting the drying times between coats.
• Apply 2 to tres coats of paste on the screw heads.
• Use corner tape and joint tape in corners and corners respectively.
• Each of the layers should be slightly wider than the previous one.
• Apply the decoration layer after the joint treatment ensuring that the applied paste is completely dry, dust-free and clean.
• It is necessary to regulate the absorption of the plate and paste before finishing by means of primer or plaster recommended by the manufacturer.